ID series pipes and project-specific couplings are produced in different diameters and sizes in accordance with EN 13476-3.

100 – 150 – 200 – 300 – 400 – 500 mm Injection, 600 – 800 – 1000 mm Readymade

ID series pipes and project-specific elbows are produced in different diameters and sizes in accordance with EN 13476-3.

100 – 150 – 200 – 300 mm 45° ve 90° Injection, 400 mm and over Readymade

ID series pipes and project-specific Y Branch are produced in different diameters and sizes in accordance with EN 13476-3.

100/100, 150/150, 200/150, 200/200, 300/150, 300/200 Injection, 150/100, 200/100, 200/150 PVC out Injection

ID series pipes and project-specific Tee Branch are produced in different diameters and sizes in accordance with EN 13476-3.

100/100 mm 90°, 150/150 mm 90°, 200/200 mm 90° T Branch Injection are produced.

ID series pipes and project-specific reduction are produced in different diameters and sizes in accordance with EN 13476-3.

200/100, 200/150 Injection, all other products are produced as apparel.

It is combined with the claw-fit method. It is produced in two types as Round and Tunnel Type in accordance with TS 9128/TS 13492.

Round 100-160-200 mm ve tunnel 160-200 mm muff ve 160-90° Elbow Injection

ID series pipes and project-specific end cap are produced in different diameters and sizes in accordance with EN 13476-3.

150 mm, 200 mm, 300 mm Injection, all other products are manufactured from apparel.

It saves time and economy as it is light and available on connection points.

Due to its HDPE structure, it is resistant to acids and ground movements at the maximum level.